Examples for new buildings:

1. The house entry is set up before the floor slab is created, aligned with the batter board and temporarily fixed. Auxiliary structures made of wood or steel reinforcement of the base plate can be useful for this. The house entry is then cast into the concrete when the floor slab is created. The concrete must be sufficiently compacted all around in the area of ​​the house entrance!

2. The house entry is installed in a pre-laid empty pipe. Common empty pipes are KG pipes or cable protection pipes. The bending radius (R) must be taken into account when creating the empty pipe. If an approved casing pipe is not used in the area through the base plate (not permitted: KG pipe, KG2000 pipe, HT pipe, cable protection pipe, etc. Approved casing pipe available at www.schuck-leerrohrsystem.de), this piece of pipe must be used before installing the pipe House entry (1) in this area must be removed. The casting directly between the house entry (1) and the base plate (10) over the minimum casting length of 150mm must be ensured and adhered to! Further installation is carried out as described in these instructions.

Examples for existing buildings:

3. On the outer wall, a core hole is drilled vertically downwards in the building through the floor plate. Excavation is carried out in front of the building and access to the core drilling is uncovered, through which the house entry can be led. Installation is then carried out as described in these instructions.

4. On an outside wall, an approximately 45° sloping hole is drilled through the floor plate towards the outside of the building. The position and angle must be chosen so that the core drilling in front of the building achieves sufficient pipe coverage. Further installation is carried out as described in these instructions.